Casa container pieghevole, montaggio rapido direttamente dalla fabbrica, tipo Z.

Packed Height, Floor Area and Shipping Mass

A z type foldable container house arrives as a flat pack of frame, panels and fittings. The pack runs 5.8 m long and weighs about 1,100 kg, so one forklift handles it. Parts are numbered against the drawing. Opened, the shell becomes one clear room, with the wiring already inside the walls, every part numbered and nothing loose in the crate.

Square Tube Frame and Cast Corner Fitting

Welded into a rectangle, 1.5 mm galvanized square tube gives the chassis its shape and its stiffness under load. Cast corner fittings tie the posts to the girders. Secondary beams cross the sill, and a sidewall frame carries the panel weight down to them. Welds are checked before paint.

Frame parts list
· 1.5 mm square tube cut to the drawing
· Cast corner fitting at every post end
· Top and bottom girder with beam stubs
· Side wall frame welded square
· Base plate under each post foot

Sandwich Wall, Roof Tile and Floor Board

External walls of a z type foldable container house take a 50 mm sandwich panel, skinned in steel on both faces. Roof sheeting is a tile profile sheet over purlins, and the floor is a board deck with a sealed edge trim. Joints close on a stepped groove, which turns water away from the core. Panel edges are taped.

Pacchetto pannelli e tetto
· Twin steel skins on a panelled core
· Roof tile sheet with ridge and barge caps
· Floor board with a sealed edge trim
· Stepped groove on the wall joint
· Foil tape roll and gasket strip Joints close on a stepped groove, which turns water away from the core, and panel edges are taped before the trims go on. The roof tile sheet sits over purlins with ridge and barge caps to finish the line.

Entry Door, Sliding Window and Wet Pod

The doorway takes a door leaf in a welded frame, with a lock bar across it. Window sashes slide, screened and set to the drawing. Inside the pod sit a pan and cistern, a basin, a mirror and a shower tray. Feed pipes and the drain stub come out under the floor.

Door, window and wet pod
· Door leaf, hinged, with a lock bar
· Sliding sash and a fly screen
· Moulded shower tray and waste
· Pan and cistern set
· Basin with a tap and bracket
· Mirror with a shelf

Film Finish, Colour and Four Step Handover

Colour, wall film and window position get chosen on the order sheet. Wood grain film suits a camp or a cabin, and plain grey suits an office. Films go on in the plant. Canopy brackets over the door hang on the same frame, with no cutting on site.

Finish and layout options
· Wood grain or plain grey film
· Extra partition for a two room plan
· Colour sample card for the order
· Canopy over the entrance door
· Opening schedule for the panels

Four steps take a z type folding container house from crate to a closed shell. The frame is set on pads, the walls swing up and pin at the corners, and the roof is lifted into place. Cams close along the roof edge, then the end panels seat. Hand tools do the rest.

Site tools and crew
· Forklift rated to 3.5 t
· Socket set and a rubber mallet
· Brass drift for the hinge pins
· Spirit level and a hose

Flusso di produzione dell'officina

Introduzione alla fabbrica

Siamo un'azienda specializzata nella produzione di case container prefabbricate, case container espandibili, case container pieghevoli e bagni prefabbricati mobili. Progettiamo, produciamo ed esportiamo soluzioni abitative modulari per hotel, ville, uffici, dormitori, magazzini, officine e cantieri edili. Il nostro stabilimento si estende su una superficie di 50.000 metri quadrati e si trova a Guangzhou. I visitatori sono i benvenuti.