Bureau conteneur pliable de type X pour chantier de construction

Folded Depth, Floor Area and Unit Weight

Open, the x type folding container office gives 14.5 m² of floor, room for three desks and a small table, and folded the body becomes a shallow pack. Shipping weight is 1,100 kg on four corner castings, and a small crew slides the pack into line before the hinges move, while a standard flatbed takes the pack, and pinning the roof clears 2,265 mm inside.

Galvanized Frame With Welded Corner Posts

Galvanized square tube forms the frame, with a post at each corner and a rail along the sill. Corner posts carry the roof load down to the castings, so no panel takes weight. Both long sides hinge through their full height. Diagonal braces hold the rectangle square until the roof frame is pinned, and a powder coat in the ordered colour covers every tube, weld and cut end.

Wall Panels, Floor Deck and Clear Height

Walls are 50 mm sandwich panels, steel skinned on both faces, and the roof repeats that build under a profiled sheet. Inside, a 15 mm cement board sits below a wear layer that takes office chairs. Taped and trimmed joints read as one surface. That build holds heat out on a sunny site and keeps warmth in winter.

Clear height under the ceiling is 2,265 mm, enough for a standing adult and a light fitting. Underfoot, the floor carries a full room of people and filing cabinets, and load spreads through the sill beams rather than the panel edges. Cable trays and ducting sit in the ceiling void, reached through removable boards. Nothing hangs below the ceiling line, so desks can go anywhere.

Ceiling Lights, Sockets and Distribution Board

Wiring gets pulled at the plant and tested before the panels close over it. A board by the door holds a main breaker, a leakage trip and a circuit for the air conditioner. Sockets sit at desk height on both long walls, and the LED ceiling lights switch in two groups. A 1.5 kW split unit runs from its own outlet, so the x type folding container office stays usable in summer. Sockets sit at desk height on both long walls, so a desk or a filing line never blocks an outlet. The LED lights switch in two groups, one for each end of the room, and the air conditioner runs from its own outlet rather than the socket ring.

Steel Entry Door, Sliding Windows and WC

Entry is a 900 mm steel door with a 1,970 mm leaf and a lock bar. Two sliding windows face each other across the room, each with a fly screen. Cross flow keeps the air fresh without propping the door open. A small washroom holds a WC, a basin and a mirror. Bead and trim seal the wet corner.

Folding Sequence for a Two Person Crew

Two people can raise the x type folding container office in a few hours. Four pads take the pack, the banding comes off and the roof frame lifts clear of the walls. Long walls swing up on their hinges, and pins drop into the corners. End panels slide down into the gasket channel. Cam locks pull the roof seam shut. No welding, no wet trades and no scaffolding are needed.

Flux de production en atelier

Présentation de l'usine

Nous sommes un fabricant professionnel spécialisé dans les maisons conteneurs préfabriquées, extensibles et pliables, ainsi que dans les salles de bains mobiles préfabriquées. Nous concevons, produisons et exportons des solutions d'habitat modulaires pour les hôtels, les villas, les bureaux, les résidences étudiantes, les entrepôts, les ateliers et les chantiers. Notre usine, située à Guangzhou, s'étend sur 50 000 mètres carrés. Nous serons ravis de vous accueillir.